Zanussi ZCM700X Bedienungsanleitung PDF herunterladen (Seite 6)

Hob Burners

To light a burner:

- turn the relevant control knob anticlockwise to

maximum position.

- At the same time push the electric ignition button

which is marked with a little spark.

- Upon ignition, keep the knob pushed down about

5 seconds, then adjust the flame as required.

If the burner does not ignite, turn the control knob to

zero, and try again.

When switching on the mains, after installation or

a power cut, it is quite normal for the spark

generator to be activated automatically.

To ensure maximum burner efficiency, you should only

use pots and pans with a flat bottom fitting the size of

the burner used (see table).

If you use a saucepan which is smaller than the

recommended size, the flame will spread beyond

the bottom of the vessel, causing the handle to

overheat.

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid

simmering.

Take care when frying food in hot oil or fat, as the

overheated splashes could easily ignite.

If the control knobs become difficult to turn, please

contact your local Zanussi Service Centre.

Burner minimum maximum

diameter diameter

Large (rapid) 160 mm. 260 mm.

Medium (semi-rapid) 120 mm. 240 mm.

Small (Auxiliary) 80 mm. 160 mm.

Central (2 crown) 180 mm. 260 mm.

Operation

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Keine Kommentare

Zanussi ZCM700X Bedienungsanleitung Seite 6