ENUser manualFreezerZFU27400WA
Problem Possible cause SolutionThe temperature in thefreezer is too high.The temperature regulator is not setcorrectly.Set a lower temperature. Many
the wall unit must be at least 100 mm . Ideally,however, the appliance should not be posi-tioned below overhanging wall units. Accuratelevelling is en
1Green and Yellow: Earth3Brown: Live5Blue: NeutralAs the colours of the wires in the mains lead ofthis appliance may not correspond with the col-oured
AB7. Unscrew the pin(A) and screw it onthe opposite side.8. Remove the cap(B) and position it onthe opposite side.9. Screw the lowerhinges.10. Refit t
14 www.zanussi.com
15www.zanussi.com
www.zanussi.com/shop 280151026-A-502012
ContentsSafety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Product description _ _ _ _ _ _ _ _ _ _ _ _ _ 5Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
During transportation and installation of theappliance, be certain that none of the com-ponents of the refrigerant circuit becomedamaged.If the refrig
• It is advisable to wait at least four hours be-fore connecting the appliance to allow the oilto flow back in the compressor.• Adequate air circulati
Product description142351Thermostat2Flaps3Freezer baskets4Rating plate5Maxibox basketsControl panel1 2 3 4 51Alarm Light2Fast Freeze Indicator3Fast Fr
Temperature regulationThe temperature is automatically regulated.To operate the appliance, proceed as follows:• turn the Temperature regulator toward
12First useCleaning the interiorBefore using the appliance for the first time,wash the interior and all internal accessorieswith lukewarm water and so
• make sure that the commercially frozen food-stuffs were adequately stored by the retailer;• be sure that frozen foodstuffs are transferredfrom the f
Activate the Fast Freeze function for somehours so that it can reach the sufficient storingtemperature as soon as possible.Caution! Never use sharp me
Kommentare zu diesen Handbüchern