Zanussi FCS1020C Bedienungsanleitung PDF herunterladen (Seite 20)

you will have to purchase a new, longer hose

specially designed for this type of use.

Water drainage

The end of the drain hose can be positioned in

three ways:

Hooked over the edge of a sink using

the plastic hose guide supplied with

the machine.

In this case, make sure the end cannot come

unhooked when the machine is emptying. This

could be done by tying it to the tap with a

piece of string or attaching it to the wall.

In a sink drain pipe with a trap.

650-800 mm

The drain hose can be connected directly into

the pipe (e.g. beneath a washtub or sink),

above the water trap. The drain hose must be

arranged so that some part of it’s length is

routed up to a level corresponding to the top

edge of the tub and fixed in place there.

Directly into a drain pipe at a height of

not less than 65 cm and not more than 80 cm.

Their must be an air gap around and below the

end of drain hose. This means that the internal

diameter of the standpipe must be larger than

the outer diameter of the hose.

650-800 mm

40 mm

The hose must not be sticked into the stand-

pipe more than 50 mm and it has to be fixed in

this position. The drain hose must not be

kinked.

The drain hose can be extended up to total 3,5

m. For the extension piece use a hose with an

internal diameter at least as large as that of the

machine's own hose. Use a suitable hose con-

nector.

Information on the electrical connection is giv-

en on the rating plate on the inner edge of the

appliance door.

Check that your domestic electrical installation

can take the maximum load required, also tak-

ing into account any other appliances in use.

Caution! Connect the machine to an

earthed socket.

Caution! The manufacturer does not

accept any responsibility for damage

or injury through failure to comply with

the above safety precaution.

20

www.zanussi.com

1 2 ... 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare