Zanussi ZRA33103WA Bedienungsanleitung PDF herunterladen (Seite 10)

INTERNAL LIGHT

• The type of lamp used for this appliance is not

suitable for household room illumination

CARE AND CLEANING

WARNING! Risk of injury or damage

to the appliance.

• Before maintenance, deactivate the appliance

and disconnect the mains plug from the mains

socket.

• This appliance contains hydrocarbons in the

cooling unit. Only a qualified person must do the

maintenance and the recharging of the unit.

• Regularly examine the drain of the appliance and

if necessary, clean it. If the drain is blocked,

defrosted water collects in the bottom of the

appliance.

DISPOSAL

WARNING! Risk of injury or

suffocation.

• Disconnect the appliance from the mains

supply.

• Cut off the mains cable and discard it.

• Remove the door to prevent children and pets

to be closed inside of the appliance.

• The refrigerant circuit and the insulation

materials of this appliance are ozone-friendly.

• The insulation foam contains flammable gas.

Contact your municipal authority for information

on how to discard the appliance correctly.

• Do not cause damage to the part of the cooling

unit that is near the heat exchanger.

CONTROL PANEL

SWITCHING ON

1. Connect the mains plug to the mains socket.

2. Turn the Temperature regulator clockwise to a

medium setting.

SWITCHING OFF

To turn off the appliance, turn the Temperature

regulator to the "O" position.

TEMPERATURE REGULATION

The temperature is automatically regulated.

To operate the appliance, proceed as follows:

1. turn the temperature regulator towards lower

settings to obtain the minimum coldness

2. turn the temperature regulator towards higher

settings to obtain the maximum coldness

A medium setting is generally the most

suitable. However, the exact setting

should be chosen keeping in mind that

the temperature inside the appliance

depends on:

• room temperature

• frequency of opening the door

• quantity of food stored

• appliance location.

If the ambient temperature is high or

the appliance is fully loaded, and the

appliance is set to the lowest

temperature, it may run continuously

causing frost to form on the rear wall.

In this case the temperature regulator

must be set to a higher temperature to

allow automatic defrosting and reduce

energy consumption this way.

CARE AND CLEANING

WARNING! Refer to Safety chapters.

CLEANING THE INTERIOR

Before using the appliance for the first time, wash

the interior and all internal accessories with

10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare