
9
2. The Hob Burners
To the symbol on the knob corresponds a symbol
on the control panel (fig. 8).
Each burner has a safety device. In case the
flame dies out the safety device stops the gas
supply.
Off
Maximum level
Minimum level
Use the maximum level for boiling and the
minimum for smothering and maintaining boiling.
Choose always positions between the minimum
and maximum, never between maximum and off.
fig. 8
Do not close the lid if the hob is hot, the lid
could be damaged.
Ignition of the burners
1. Push the knob and turn it left to the symbol “big
flame”.
2. In the same time, push the electronic ignition
knob (fig. 9) for obtaining sparkles. Keep it
pushed till turning up of the flame (1 spark /
second).
3. The hob burners are provided with a safety
device. The control knob must be pressed
in for approximately 10 seconds until the
safety valve automatically keeps the flame
lit.
4. Release the knob and watch that the burner
has ignited. Upon ignition, adjust the flame as
required.
If for any reason the flame should extinguish turn
off the relevant control know, leave for at least
one minute and then re-ignite.
Lack of power
1. Push the corresponding knob in completely
and turn it left to the symbol “big flame” and
ignite with a match.
2. The hob burners are provided with a safety
device. The control knob must be pressed
in for approximately 10 seconds until the
safety valve automatically keeps the flame
lit.
3. Release the knob and watch that the burner
has ignited. Upon ignition, adjust the flame as
required.
If for any reason the flame should extinguish turn
off the relevant control know, leave for at least
one minute and then re-ignite.
If after a few attempts the burner does not ignite,
check that the burner ring and its cap are
correctly positioned (fig. 10).
fig. 9
Burner cap
Burner
ring
Thermocouple
(safety device)
fig. 10
Kommentare zu diesen Handbüchern