Zanussi ZCV680TCXA Bedienungsanleitung PDF herunterladen (Seite 17)

Location of the appliance

You can install your freestanding appliance with

cabinets on one or two sides and in the corner.

A

Minimum distances

Dimension mm

A 685

Levelling of the appliance

Use small feet on the bottom of appliance to set

the appliance top surface level with other

surfaces.

Electrical installation

WARNING!

The manufacturer is not responsible

if you do not follow the safety

precautions from Safety chapters.

This appliance is supplied without a main plug

or a main cable.

Applicable types of cables for different phases:

Phase Min. size cable

1 3x10.0 mm²

Phase Min. size cable

3 with neutral 5x1.5 mm²

WARNING!

The power cable must not touch the

part of the appliance shaded in the

illustration.

Covering terminal board

• The recommended cross-section area is six

square millimetres (6 mm²).

• When you refit the mains terminal cover,

make sure that the lower tabs are located

inside the bottom edge of the aperture,

before you fix the two screws into the top

edge of the mains terminal cover.

• Make sure that the cover is securely

fastened.

To open the cover of terminal board

obey the procedure in opposite

sequence.

Terminal board

Do not remove blanking plates.

Make sure that the links are fitted as shown.

www.zanussi.com 17

1 2 ... 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare