Zanussi ZGG646ICN Bedienungsanleitung PDF herunterladen (Seite 5)

Contents

This appliance complies with the following

E.E.C. Directives:

- 73/23 - 90/683 (Low Voltage Directive);

- 89/336

(Electromagnetical Compatibility Directive);

- 93/68 (General Directives)

and subsequent modifications.

Instruction for the User

Guide to Use the instructions

The following symbols will be found in the text to guide

you throughout the Instructions:

Safety Instructions

Step by step instructions for an operation

Hints and Tips

Environmental Information

Important Safety Information 2

Instruction for the User 3

Maintenance and Cleaning 4

Service and original spare parts 5

Technical Data 6

Instruction for the Installer 6

Electrical Connection 7

Adaptation to different types of gas 8

Building In 9

Possibilities for insertion 10

For the User

For the Installer

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to

remove any protective materials, which were put

on in the factory.

Hob Burners Control Knobs

The hob burners control knobs are situated on the hob

front panel. The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the Burners

• For easier lighting, proceed before putting a pan

on the pan support.

Push in the relevant knob and turn it anticlockwise

to "maximum position". After lighting the flame,

keep the knob pushed down for about 5 seconds.

This will allow the "thermocouple" (Fig. 1 - lett. D)

to be heated and the safety device to be switched

off, otherwise the gas supply would be interrupted.

Then, check the flame is regular and adjust it as

required.

If you cannot light the flame even after several

attempts, check the "cap" (Fig. 1 - lett. A) and

"crown" (Fig. 1 - lett. B) are in the correct position.

To put the flame out, turn the knob to the symbol .

Fig. 1

A - Burner cap

B - Burner crown

C - Ignition candle

D - Thermocouple

•

• Always turn the flame down or put it out before

taking the pans off the burner.

• In the absence of electricity, ignition can occur

without the electrical device; in this case approach

the burner with a flame, push the relevant knob

down and turn it anti-clockwise until it reaches

the"maximum" position.

• When switching on the mains, after installation

or a power cut, it is quite normal for the spark

generator to be activated automatically.

•

1 2 3 4 5 6 7 8 9 10 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Zanussi ZGG646ICN Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Zanussi ZGG646ICN