Zanussi ZEE3921IXA Bedienungsanleitung PDF herunterladen (Seite 17)

Installation

Warning! Refer to the Safety chapters.

Installation

Warning! Read and follow the instructions

carefully. There is a risk of injury or damage

to the appliance.

• Make sure that there is no damage to the ap-

pliance from the transportation. Do not con-

nect a damaged appliance. Speak to the sup-

plier if necessary.

• Install built-in appliances only after you as-

semble the appliance into correct built-in

units and work surfaces. Make sure that built-

in units and surfaces obey the standards.

• Obey all orders and standards in force in the

country where you use the appliance (safety

standards, recycling standards, electrical

safety standards etc.)

Warning! Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of voltage.

• If the fixing bracket is near to the terminal

block, do not let the connection cable come

in contact with the edge of the bracket.

Electrical connection

• Make sure that the rated voltage and type of

power on the rating plate agree with the volt-

age and the power of the local power supply.

• This appliance is supplied with a mains cable.

It has to be supplied with a correct plug

which can hold the load that the rating plate

rates. Make sure that you install the plug in a

correct socket.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug.

• There is a risk of fire when the appliance is in

connection with an extension cable, an

adapter or a multiple connection. Make sure

that the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to a

temperature higher than 90° C.

Make sure that you connect the blue neutral ca-

ble to the terminal with a letter "N" on it. Con-

nect the brown (or black) phase cable to the

terminal which has a letter "L". Keep the phase

cable connected at all times.

Replacement of the connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make sure

that the cable section is applicable to the volt-

age and the working temperature. The yellow/

green earth wire must be approximately 2 cm

longer than the brown (or black) phase wire.

Assembly

40-50 mm

55 mm

30 mm

min. 650 mm

490 mm

min. 100 mm

270 mm

B

A

A) seal to remove

B) supplied brackets

Caution! Install the appliance only on a

worktop with flat surface.

17

www.zanussi.com

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare