Zanussi ZGF982CX Bedienungsanleitung PDF herunterladen (Seite 9)

Important safety requirements

This hob must be installed in accordance with the Gas

Safety (Installation and Use) Regulations (Current

Edition) and the IEE Wiring Regulations (Current

Edition).

Detailed recommendations are contained in the

following British Standards Codes Of Practice: B.S.

6172/ B.S. 5440, Part 2 and B.S. 6891 Current Editions.

The hob should not be installed in a bed sitting room

with a volume of less than 20 m

. If it is installed in a

room of volume less than 5 m

an air vent of effective

area of 110 cm

is required. If it is installed in a room of

volume between 5 m

and 10 m

an air vent of effective

area of 50 cm

is required, while if the volume exceeds

11 m

no air is required.

However, if the room has a door which opens directly to

the outside no air vent is required even if the volume is

between 5 m

and 11 m

If there are other fuel burning appliances in the same

room, B.S. 5440 Part 2 Current Edition, should be

consulted to determine the requisite air vent

requirements.

Location

The hob may be located in a kitchen, a kitchen/diner or

bed sitting room, but not in a bathroom or shower room.

Before making the cut out in the worktop ensure that

the edges of the hob that are to be near either a side or

rear wall have a minimum distance of 55 mm. between

the edge of the hob and the wall.

The minimum distance combustible material can be

fitted above the hob in line with the edges of the hob is

400 mm. If it is fitted below 400 mm. a space of 50 mm.

must be allowed from the edges of the hob.

The minimum distance combustible material can be

fitted directly above the hob is 700 mm.

A minimum distance of 100 mm. must be left between

the side edges of the hob and any adjacent cabinets or

walls.

INSTALLATION GUIDANCE INSTRUCTIONS

CLEARANCES REQUIRED WHEN FITTING

ZANUSSI GAS HOB

WITHOUT A COOKER HOOD ABOVE

700 mm

400 mm

100 mm

400 mm

50 mm

55 mm

FO 2027*

INSTALLATION GUIDANCE INSTRUCTIONS

CLEARANCES REQUIRED WHEN FITTING

ZANUSSI GAS HOB

WITH A COOKER HOOD ABOVE

650 mm

400 mm

100 mm

50 mm

55 mm

FO 2028*

Installation

IMPORTANT

This hob must be installed by qualified personnel

to the relevant British Standards.

Any gas installation must be carried out by a

registered CORGI installer.

The manufacturer will not accept liability, should

the above instructions or any of the other safety

instructions incorporated in this book be ignored.

On the end of the shaft, which includes the GJ 1/2"

threaded elbow, adjustment is fixed so that the washer

is fitted between the components as shown in the

diagram. Screw the parts together without using

excessive force.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Zanussi ZGF982CX Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Zanussi ZGF982CX