Zanussi ZKF325X Bedienungsanleitung Seite 6

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 5
22
REMOVE
Securing the hob into the cut out
Before fitting the hob into the cut out, the sealing
gasket supplied with the hob must be fitted to the
edge of the cut out. It is essential that no gaps are
left in this seal in order to prevent spillage near the
hob seeping into the cabinet below.
1) Place the sealing gasket (A) all around the edge
of the cut out.
2) Fit the hob in the cut out and push it down until
it comes in contact with the kitchen top surface.
Then remove the excess sealing.
3) To remove the hob from the cut-out, lift the edge
of the hob by means of the edge of a screw-
driver.
Warnings about building in the hob
Ensure the eventual plastic covering of the
furniture unit has been fixed with a heatproof
adhesive (100°C heatproof).
Fitting of solid wood panel borders on the working
top or behind the hob is allowed provided that
minimum distances are observed.
A insulation panel which can only be removed
with tools must be fitted under the hob at a
minimum distance of 50 mm.
If the hob must be installed beside a cupboard,
ensure a minimum distance of 40 mm. is
observed and the side of the cupboard is covered
with heatproof material.
Before making the cut out in the worktop ensure
that the edges of the hob that are to be near the
rear wall have a minimum distance of 55 mm.
A minimum distance of 100 mm. must be
observed between the hob and an eventual side
wall exceeding the working top height.
Hanging furniture units or cooker hoods must be
fitted at a minimum height of 650 mm. from the
hob.
Combustible or not heatproof materials must be
kept away from the appliance.
Rear wall
Building-in dimensions
The dimensions of the cut-out are given in the
diagrams.
If 30 cm. hobs with different functions must be
built in one beside the other (e.g. 2 Plate Hob
+ 2 burners Hob), the minimum distance shown
in the diagram must be observed.
Seitenansicht 5
1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare