Zanussi ZDF26004XA Bedienungsanleitung

GETTING STARTED?EASY.User ManualZDF26004XAEN User ManualDishwasher

ADDING MULTI-TABLETS212030• Adjust the water softener to the lowest level.THE AUTO OFF FUNCTIONThis function decreases energy consumption bydeactivati

END OF THE PROGRAMMEWhen the programme is complete, the displayshows: 0:00.• Press on/off or wait 5 minutes for the Auto OFFfunction to automatically

• Put light items in the upper basket. Make surethat the items do not move.• Make sure that the spray arm can move freelybefore you start a programme.

• Do not use abrasive products, abrasive cleaningpads or solvents.INTERNAL CLEANING• Carefully clean the appliance, including therubber gasket of the

Problem and alarm code Possible cause and solutionThe program lasts too long. • If the delayed start option is set, cancel the delay setting or waitfo

Problem Possible cause and solutionPoor drying results. • Tableware has been left for too long inside a closed appli-ance.• There is no rinse aid or t

Problem Possible cause and solutionLimescale deposits on the table-ware, on the tub and on the in-side of the door.• The level of salt is low, check t

ENVIRONMENTAL CONCERNSRecycle materials with the symbol . Put thepackaging in relevant containers to recycle it. Helpprotect the environment and huma

18

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

WWW.ZANUSSI.COM/SHOP156925490-A-342017

• Put the cutlery in the cutlery basket with the sharp endspointing down or put them in the cutlery drawer in a horizontalposition with the sharp edge

• Do not remove the dishes from the applianceuntil the programme is complete. Somedetergent may remain on the dishes.• The appliance can release hot s

CONTROL PANEL213451On/off button2Display3Indicators4Delay button5Programme buttonsINDICATORSIndicator DescriptionXtraDry indicator.Rinse aid indicator

PROGRAMMESProgrammeDegree of soilType of loadProgramme phasesConsumption values1)Duration(min)Energy(kWh)Water(l) 2)Normal soilCrockery andcutlery• Pr

RESET FUNCTIONUse Reset to:• Reset the currently running programme.• Stop the countdown of the Delay option.• Bring the appliance back to the programm

• The indicator flashes.• The display shows the current setting:– = rinse aid empty notificationactivated.– = rinse aid empty notificationdeactiva

ADDING SALTBefore the first use, put one litre of water in the salt container.CAUTION! Water and salt can come out of the salt container during fillin