Zanussi ZDT 6454 Bedienungsanleitung PDF herunterladen (Seite 21)

If the malfunction or fault code reappears con-

tact the Service Force Centre.

For other fault codes not described in the above

chart, please contact your Service Force Cen-

tre.

The wash results are not satisfactory

The dishes are not clean • The wrong washing programme has been selec-

ted.

• The dishes are arranged in such a way as to stop

water reaching all parts of the surface. The baskets

must not be overloaded.

• The spray arms do not rotate freely due to incorrect

arrangement of the load.

• The filters in the base of the washing compartment

are dirty or incorrectly positioned.

• Too little or no detergent has been used.

• Where there are limescales deposits on the dishes;

the salt container is empty or the incorrect level of

the water softener has been set.

• The drain hose connection is not correct.

• The salt container cap is not properly closed.

The dishes are wet and dull • Rinse aid was not used.

• The rinse aid dispenser is empty.

There are streaks, milky spots or a bluish coating on

glasses and dishes

• Decrease rinse aid dosing.

Water drops have dries onto glasses and dishes • Increase rinse aid dosing.

• The detergent may be the cause. Contact the de-

tergent manufacturer’s consumer care line.

If after all these checks, the problem persists,

contact your local Service Force Centre.

Contact your local Service Force Centre, quot-

ing the model (Mod.), product number (PNC)

and serial number (S.N.). This information can

be found on the rating plate located on the side

of the dishwasher door.. So that you always

have these numbers at hand, we recommend

you to make a note of them here:

Mod. :. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Downloaded from DishWasher-Manual.com Manuals

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Keine Kommentare

Zanussi ZDT 6454 Bedienungsanleitung Seite 21