Zanussi ZUD790F Bedienungsanleitung

FREEZERZU 790 FINSTRUCTION BOOKLET2222 259-06

10TECHNICAL SPECIFICATIONSPOWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 HzTOTAL POWER ABSORBED 90 W AVERAGE DAILY UNITS ELECTRICITY * 1,15 kWhGRO

StartingBefore the appliance is installed into the recessplug into the mains and switch on. Check thatthe mains on light comes on and the control dial

Note1. Do not place sealed containers of carbonatedliquide such as fizzy drinks into the freezeras it creates pressure on the container whichmay cause

HEALTH AND SAFETY GUIDELINES GBBecause of consumer demand,preservatives have been removed frommany pre-prepared foods. This together withthe changes i

14MAINTENANCE AND CLEANING Before any maintenance or cleaning work iscarried out, DISCONNECT the appliance fromthe ELECTRICITY supply.Internal cleanin

15WHAT HAPPENS IF SOMETHING IS WRONG?The appliance does not work Vibration or abnormal noises...Other points to check...GBBefore contacting your loca

16PEACE OF MIND FOR TWENTYFOUR MONTHS Zanussi standard guaranteeconditionsThis guarantee is in addition to your statutoryand other legal rights.We, Za

WARNINGS2IT IS MOST IMPORTANT THAT THIS INSTRUCTION BOOK SHOULD BE RETAINED WITH THEAPPLIANCE FOR FUTURE REFERENCE. SHOULD THE APPLIANCE BE SOLD OR TR

32222 259-06CONTENTSDescription of the appliance 4Installation 5 Positioning 5 Before using 5 Location 5 Door reversibility 6 Fitting a decorative do

DESCRIPTION OF THE APPLIANCEA- Freezing fresh food B- Frozen food storageC- Freezer calendar 4GBBA36912C

INSTALLATIONGBWarningIF YOU ARE DISCARDING AN OLDAPPLIANCE THAT HAS A LOCK OR CATCHON THE DOOR, YOU MUST ENSURE THAT ITIS MADE UNUSABLE TO PREVENT YOU

6Door reversibilityRemove the two screws which fix the upperhinge to the door.Carefully lean the appliance on its back andremove the plastic insert (F

Lay the panel face down (Fig. 6). Position thetop bracket on the panel, making sure that thereis an equal distance between it and the sidesand that it

Check the position again by slackening thescrews and pins then, once the best positionhas been obtained, fully tighten all the fixings.Cover the visib

The electrical connectionsWARNING: THIS APPLIANCE MUST BEEARTHED.The manufacturer declines any liabilityshould this safety measure not be observed.If