Zanussi ZKG2125 Bedienungsanleitung

ENUser manualWasher DryerZKG 2125

Programme - Maximum and Minimum Temperature -Cycle Description - Maximum Spin Speed - Maxi-mum Fabrics Load - Type of LaundryOptionsDetergent Com-part

Programme - Maximum and Minimum Temperature -Cycle Description - Maximum Spin Speed - Maxi-mum Fabrics Load - Type of LaundryOptionsDetergent Com-part

Degree of Drying Type of Fabric Max Load Spin SpeedSuggesteddrying timein MinsIRON DRYSuitable for ironingCotton and linen(sheets, tablecloths,shirts,

Blood: treat fresh stains with cold water. Fordried stains, soak overnight in water with a spe-cial detergent then rub in the soap and water.Oil based

Drying HintsPreparing the drying cycleAs a dryer, the appliance works on the conden-sation principle.Therefore, the water tap must be open andthe drai

laundry in the machine, to remove anymanufacturing residue from the drumand tub. Pour 1/2 a measure of deter-gent into the main wash compartmentand st

Select the required programme by meansof the programme selector dial (1)Turn the programme selector dial to the re-quired programme.The green pilot li

Important! • The selected delay can be changed only afterselecting the washing programme again.• The door will be locked throughout the delaytime. If

Use - DryingDrying onlyThe drying maximum load is 3 kg for cotton and3 kg for synthetics.The water tap must be open and the drain hosemust be position

• After the drying phase, thoroughly clean theempty drum, the gasket and the door with awet rag.Care and cleaningWarning! You must DISCONNECT theappli

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Product description _ _ _ _ _ _ _ _ _ _ _

Open the pump door.Put a container below the recess of the drainpump to collect the water that flows out.Press the two levers and pull forward thedrai

Caution! When the appliance is in useand depending on the programme selectedthere can be hot water in the pump.Never remove the pump cover during a wa

6. press the two levers and pull forward thedrainage duct to let the water flow out;7. when the container is full of water, put thedrainage duct back

Problem Possible cause/SolutionThe machine does not fill:The water tap is closed. • Open the water tap.The inlet hose is squashed or kinked. • Check t

Problem Possible cause/SolutionThe door will not open:The programme is still running.• Wait the end of washing cycle.The door lock has not been releas

Problem Possible cause/Solution The laundry is full of differentcolored fluff:The fabrics washed in the previous cycle released fluff of a different c

After removing all thepackaging, carefullylay machine on it'sback to remove thepolystyrene base fromthe bottom.Remove the powersupply cable and t

35°45°Open the porthole and extract the inlet hose.Connect the hose with the angled connectionto the machine. Do not place the inlet hosedownwards. An

Packaging materialsThe materials marked with the symbol are re-cyclable.>PE<=polyethylene>PS<=polystyrene>PP<=polypropyleneThis mea

29www.zanussi.com

• Do not change the specification of this appliance.• Obey the maximum load volume of 6 kg (refer to the “Programmechart” chapter).• If the supply cor

30 www.zanussi.com

31www.zanussi.com

www.zanussi.com/shop 132969992-A-062013

Water connection• Make sure not to cause damage to the waterhoses.• The appliance is to be connected to the wa-ter mains using the new supplied hose-s

Product description1Detergent dispenser drawer2Control panel3Door opening handle4Rating plate5Drain pump6Adjustable feet123456Detergent dispenser draw

To activate this de-vice, rotate the button(without pressing it)inside the door clock-wise until the grooveis horizontal. If neces-sary use a coin.To

= Eco (Energy saving pro-gramme) = Jeans= with Prewash phase = Sport Intensive= Synthetics = Drying Programmes= Easy Iron = Rinses= Delicates

Some additional rinses will be performed. Thisoption is recommended for people who are al-lergic to detergents, and in areas where the wa-ter is very

• End of programmeWhen the programme has finished the flashing zero ( ) is displayed, the pilot light 9 and thepilot light of button 7 go out and t