Zanussi ZCG61211WA Bedienungsanleitung PDF herunterladen (Seite 23)

A

Change from natural gas to liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Change form liquid gas to natural gas

1. Unscrew approximately one turn the bypass

screw position (A).

2. Put the knob back.

3. Connect the appliance to the electricity.

WARNING!

Put the mains plug into the

mains socket only if all parts are

back into their initial position.

There is a risk of injury.

4. Light the burner.

Refer to "Hob - Daily use" chapter.

5. Turn the knob on the minimum position.

6. Remove the knob again.

7. Screw on slowly the bypass screw till the

flame becomes minimum and stable.

8. Put the knob back.

9. Set the maximum gas flow position on the

oven knob and let the oven heat for at least

10 minutes.

10. Quickly turn the knob for the oven functions

from maximum to the minimum gas glow

position.

Control the flame. Make sure the flame does not

go out when you turn the knob to the minimum

gas flow position. There must be a small regular

flame on the oven burner crown. If the flame

goes out adjust the oven burner again.

Oven injector replacement

1. Remove the bottom plate of the oven cavity

(A) to get access to the oven burner (B).

A

B

2. Release the screw (C), which keep the

burner in position.

C

3. Carefully move the burner off the injector

support (D).

D

F

E

4. Slowly move it to the left side. Make sure

that the burner bush stays on the burner

mouthpiece. Do not apply force to the wire

of the spark plug connector (F) and to the

thermocouple conductor (E).

5. Release the burner injector (D) with a 7 mm

socket spanner and replace it with a

different one.

Assemble the burner in a revers sequence.

Replace the gas type sticker near the gas

supply ramp with the one related to the new gas

type.

Adjustment of minimum level at the

oven burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the oven functions. If

there is no access to the bypass screw

dismount the control panel before

adjustment start.

3. Adjust the bypass screw (A) with a thin and

flat screwdriver.

www.zanussi.com 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare