
Problem Possible cause Remedy
The hob deactivates. You put something on the sensor
field .
Remove the object from the sen-
sor field.
Residual heat indicator does not
come on.
The zone is not hot because it
operated only for a short time.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Automatic Heat Up function does
not operate.
The zone is hot. Let the zone become sufficiently
cool.
The highest heat setting is set. The highest heat setting has the
same power as the function.
The heat setting changes be-
tween two levels.
Power management function op-
erates.
Refer to "Daily use" chapter.
The sensor fields become hot. The cookware is too large or you
put it too near to the controls.
Put large cookware on the rear
zones if possible.
comes on.
Automatic Switch Off operates. Deactivate the hob and activate it
again.
comes on.
There is no cookware on the
zone.
Put cookware on the zone.
The cookware is incorrect. Use the correct cookware.
Refer to “Hints and tips” chapter.
The diameter of the bottom of the
cookware is too small for the
zone.
Use cookware with correct di-
mensions.
Refer to “Technical information”
chapter.
and a number come on.
There is an error in the hob. Disconnect the hob from the
electrical supply for some time.
Disconnect the fuse from the
electrical system of the house.
Connect it again. If comes on
again, speak to an Authorised
Service Centre.
comes on.
There is an error in the hob be-
cause a cookware boils dry. Au-
tomatic Switch Off and the over-
heating protection for the zones
operate.
Deactivate the hob. Remove the
hot cookware. After approximate-
ly 30 seconds, activate the zone
again. If the cookware was the
problem, the error message goes
out. Residual heat indicator can
stay on. Let the cookware be-
come sufficiently cool. Check if
your cookware is compatible with
the hob.
Refer to “Hints and tips” chapter.
www.zanussi.com 11
Kommentare zu diesen Handbüchern