Zanussi ZGG782CTN Bedienungsanleitung PDF herunterladen (Seite 38)

By-pass screw

Injectors replacement

• Remove the pan supports.

• Remove the burner's caps and crowns.

• With a socket spanner 7 unscrew and remove the injectors, and replace

them with the ones required for the type of gas in use.

• Reassemble the parts, following

the same procedure backwards.

• Replace the rating label (placed

near the gas supply pipe) with the

relevant one for the new type of

gas supply. You can find this label

in the package of the injectors

supplied with the appliance.

Should the feeding gas pressure be

different or variable compared with

the required pressure, an

appropriate pressure adjuster must

be fitted on the gas supply pipe, in

compliance with the rules in force.

Adjustment of minimum level

To adjust the minimum level of the

burners, proceed as follows:

• Light the burner.

• Turn the knob on the minimum

position.

• Remove the knob.

• With a thin screwdriver, adjust the

by-pass screw.

If changing from natural gas to liquid gas, completely tighten

clockwise the screw, until a small regular flame is obtained. If changing from

liquid gas to natural gas unscrew about 1/4 turn the by-pass screw, until a

small regular flame is obtained.

• Finally check the flame does not go out when quickly turning the knob from

the maximum position to the minimum position.

This procedure can easily be carried out, anyhow the hob has been positioned

or built in the working top.

Adaptation to different types of gas

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Keine Kommentare

Zanussi ZGG782CTN Bedienungsanleitung Seite 38