Zanussi PW64 Wartungshandbuch PDF herunterladen (Seite 29)

9.2 Displaying alarms and activating individual components

1. Access the diagnostic mode (see 9.1)

2. Press button Ok/Start to begin displaying alarms:

 The display shows the last alarm that has occurred (to decode the alarm, see the table of alarms).

3. Press button Ok/Start once again to display the next to the last alarm that has occurred

4. Press button Ok/Start once again to display the third from the last alarm that has occurred

5. Press button Ok/Start repeatedly to scroll through the electronic components, as shown on the table

below.

Presses of

button

Ok/Start

Display Function activated

1 ERR CODE i 0  Displays last alarm that has occurred (for example, no alarm)

1 ERR CODE i 0  Displays the next to the last alarm (for example, no alarm)

1 ERR CODE i 0  Displays the third from the last alarm (for example, no alarm)

2 TEST ACTIVAT. 4  Activates regeneration solenoid

2 TEST ACTIVAT. 5  Activates drain pump

2 TEST ACTIVAT. 6  Activates water fill solenoid until full level is reached

2 TEST ACTIVAT. 7  Activates heating (only with water at full level!)

2 TEST ACTIVAT. 8  Activates wash pump at 2800 RPM

2 TEST ACTIVAT. 9  Cycles detergent/rinse-aid dispenser

2 TEST ACTIVAT. 10  Activates drying fan (if turbo-dry)

2 TEST ACTIVAT. 11  Activates auto-dosing (currently not used)

2 TEST ACTIVAT. 12  Activates water hardness sensor (currently not used)

Power is supplied to components when the door is closed. If no button is pushed within 60

seconds, the system automatically exits the diagnostic mode.

NB: All functions can be accessed multiple times by pressing button Ok/Start repeatedly.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 40 41

Keine Kommentare

Zanussi PW64 Wartungshandbuch Seite 29