Zanussi ZGG640ITNC Bedienungsanleitung PDF herunterladen (Seite 5)

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the by-pass screw

position.

The by-pass screw

– If you change from natural gas 20 mbar to liquid

gas, fully tighten the adjustment screw in.

– If you change from liquid gas to natural gas 20

mbar, undo the by-pass screw approximately 1/4

of a turn.

Warning! Make sure the flame does not go out when

you quickly turn the knob from the maximum

position to the minimum position.

Electrical connection

• Ground the appliance according to safety precautions.

• Make sure that the rated voltage and type of power on

the rating plate agree with the voltage and the power of

the local power supply.

• This appliance is supplied with a mains cable and

plug.

• Any electrical component must be installed or replaced

by the Service Force Centre technician or qualified

service personnel.

• Always use a correctly installed shockproof socket.

• Make sure that there is an access to the mains plug af-

ter installation.

• Do not pull the mains cable to disconnect the appli-

ance. Always pull the mains plug.

• The appliance must not be connected with an extension

cable, an adapter or a multiple connection (risk of fire).

Check that the ground connection is in conformity with

the standard and regulations force.

• The power cable must be placed in such a way that it

does not touch any hot part.

• Connect the appliance to the mains with a device that

lets to disconnect the appliance from the mains at all

poles with a contact opening width of minimum 3 mm,

eg. automatic line protecting cut-out, earth leakage

trips or fuse.

• None of a parts of the connection cable can not get a

temperature 90°C. The blue neutral cable must be con-

nected to the terminal block label with "N". The brown

(or black) phase cable (fitted in the terminal block con-

tact marked with "L") must always be connected to the

live phase.

Replacement of the connection cable

To replace the connection cable use only H05V2V2-F T90

or equivalent type. Make sure that the cable section is ap-

plicable to the voltage and the working temperature. The

yellow/green earth wire must be approximately 2 cm lon-

ger than the brown (or black) phase wire.

Building In

min. 55 mm

min. 650 mm

550 mm

min. 100 mm

30 mm

470 mm

min. 600 mm

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Zanussi ZGG640ITNC Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Zanussi ZGG640ITNC