Zanussi ZGH66424BB Bedienungsanleitung Seite 1

GETTING STARTED?EASY.User ManualZGH66424BBZGH66424XXEN User ManualHobGB IE MT

9.CAUTION! Install the appliance onlyon a worktop with flat surface.POSSIBILITIES FOR INSERTIONThe panel installed below the hob must be easy toremove

CONTROL KNOBSymbol Descriptionno gas supply / off positionignition position / maximumgas supplySymbol Descriptionminimum gas supplyDAILY USEWARNING! R

CAUTION! In the absence ofelectricity you can ignite the burnerwithout electrical device; in this caseapproach the burner with a flame, turnthe contro

CARE AND CLEANINGWARNING! Refer to Safety chapters.GENERAL INFORMATION• Clean the hob after each use.• Always use cookware with a clean base.• Scratch

TROUBLESHOOTINGWARNING! Refer to Safety chapters.WHAT TO DO IF...Problem Possible cause RemedyThere is no spark when you tryto activate the spark gene

LABELS SUPPLIED WITH THE ACCESSORIESBAGStick the adhesive labels as indicated below:MOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NO.03

OTHER TECHNICAL DATATOTAL POW-ER:Gas original: G20 (2H) 20 mbar 9 kWGas replace-ment:G30 (3+) 28-30 mbar 629 g/hG31 (3+) 37 mbar 618 g/hElectric suppl

ENERGY EFFICIENCYPRODUCT INFORMATION ACCORDING TO EU 66/2014Model identification ZGH66424BB,ZGH66424XXType of hob Built-in hobNumber of gas burner

18

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

WWW.ZANUSSI.COM/SHOP867345144-E-502018

• NEVER try to extinguish a fire with water, but switch off theappliance and then cover flame e.g. with a lid or a fire blanket.• CAUTION: The cooking

• Do not install the appliance adjacent to a dooror under a window. This prevents hot cookwarefalling from the appliance when the door or thewindow is

• Used oil, that can contain food remnants, cancause fire at a lower temperature than oil usedfor the first time.• Do not put flammable products or it

813 Current Editions and the ETCI Rules forElectrical Installations.Provision for ventilationDetailed recommendations are contained in thefollowing Br

INJECTORS REPLACEMENT1. Remove the pan supports.2. Remove the caps and crowns of the burner.3. With a socket spanner 7 remove the injectorsand replace

Supply connectionsThis hob has to be connected to 220-240 V (~50-60 Hz ) electricity supply.The hob has a terminal block which ismarked as follows:• L

ASSEMBLY1.2.3.min. 55 mmmin. 650 mm560 mm20+min. 100 mm30 mm480 mm20+min. 600 mm4.50 mm400 mmIf a furniture unit is installed at adistance of 400