Zanussi ZWG3105 Bedienungsanleitung PDF herunterladen (Seite 15)

15

Start the programme by pressing button 6

To start the selected programme, press this

button; the corresponding green pilot light

stops flashing.

On programme progress display the pilot light

A illuminates to indicate that the appliance

starts operating and the door is locked.

IMPORTANT!

If an option which is not compatible with the set

wash programme is selected, the red light of

this button flashes for 3 times.

Altering an option or a running programme

It is possible to change any option before the

programme carries it out.

Before you make any change, you must pause

the washing machine by pressing the button

6.

Changing a running programme is possible

only by resetting it. Turn the programme

selector dial to «O» and then to the new

programme position. Start the new programme

by depressing the button

6 again.

The washing water in the tub will not empty

out.

Interrupting a programme

Press the button

6 to interrupt a programme

which is running, the corresponding light starts

to flash. Press the button again to restart the

programme.

Cancelling a programme

Turn the selector dial to «O» to cancel a

programme which is running. Now you can

select a new programme.

Opening the door after the programme has

started

First set the machine to pause by pressing the

button

6.

After some minutes, the door can be opened.

If the machine is already heating, that the

water level is above the bottom edge of the

door, the door cannot be opened.

If you cannot open the door but you need to

open it you have to switch the machine off by

turning the selector dial to «O». After few

minutes the door can be opened

(Pay attention to the water level and

temperature!).

After this procedure, it will be necessary to set

the programme and the options again and then

press the button 6.

At the end of the programme

The machine stops automatically.

The pilot light of button

6 goes off while the

phase light C illuminates. The door can be

opened.

If at the end of a programme there is water in

the tub, to empty out the water follow the

following instructions:

● turn the programme selector dial to «O»

● select the «Drain» or «Spin» programme

● reduce the spin speed if needed, by means

of the relevant button

● press button 6

At the end of the cycle, turn the programme

selector dial to «O» to switch the machine off.

Remove the laundry from the drum and

carefully check that the drum is empty.

If you do not intend to carry out another wash,

close the water tap.

Leave the door open to prevent the formation

of mildew and unpleasant smells.

192996650gb.qxd 04/03/2008 17.30 Page 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare