Zanussi ZCG661GW Bedienungsanleitung PDF herunterladen (Seite 19)

A

• If you change from natural gas to liquid gas,

fully tighten the adjustment screw in.

• If you change from liquid gas to natural gas,

undo the by-pass screw approximately 1/4 of

a turn.

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the minimum

position.

Oven injector replacement

1. Remove the bottom plate of the oven cavity

(A) to get access to the oven burner (B).

2. Release the screw (C), which keep the

burner in position.

3. Carefully move the burner off the injector

support (D).

Slowly move it to the left side. Make sure

that the burner bush stays on the burner

mouthpiece. Do not apply force to the wire

of the thermocouple conductor (F).

4. Release the burner injector (D) with a 7

mm socket spanner and remove it. Replace

it with the necessary one.

5. Assemble the burner in the opposite se-

quence.

6. Replace the gas type sticker near the gas

supply ramp with the one related to the

new gas type.

Replacing the grill burner injector:

1. Release the screw which keep the grill

burner in position.

2. Release the burner injector with a 7 mm

socket spanner and remove it. Replace it

with the necessary one.

3. Assemble the burner in opposite se-

quence. Before you fix the screw, make

sure that the burner is pushed correctly to

the back panel.

Minimum level adjustment of the oven

burner:

1. Disconnect the mains plug from the mains

socket.

2. Remove the knob for the oven functions.

3. Adjust the by-pass adjustment screw (A)

with a thin-bladed screwdriver.

A

19

www.zanussi.com

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare