Zanussi ZCG661GW Bedienungsanleitung PDF herunterladen (Seite 8)

2. Turn the control knob counterclockwise to

the maximum position

. Push the knob in

and hold.

3. Release the spark generator button but

keep the control knob on this position for

approximately 10 seconds; this will let ther-

mocouple to warm up. If not, the gas sup-

ply will be interrupted.

4. Adjust the flame after it is regular.

If after some tries the burner does not

light, check if the crown and its cap are in

correct positions.

1

2

3

4

1

Burner cap

2

Burner crown

3

Ignition candle

4

Thermocouple

Warning! If the burner does not light after

10 seconds, release the control knob, turn

it into off position and try to light the burner

again.

Important! You can light the burner without

electrical device (e.g. when there is no

electricity in the kitchen). To do so, put the

flame near the burner, turn the related knob to

the maximum gas release position and push it

down for 10 seconds.

If the burner accidentally goes out, turn the

control knob to the off position and try to

light the burner again after minimum 1 minute.

The spark generator can start automatical-

ly when you switch on the mains, after in-

stallation or a power cut. It is normal.

Turning the burner off

To put the flame out, turn the knob to the sym-

bol

.

Warning! Always turn the flame down or

switch it off before you remove the pans

from the burner.

Hob - Helpful hints and tips

Energy savings

• If possible, always put the lids on the pans.

• When the liquid starts to boil, turn down the

flame to barely simmer the liquid.

Warning! Use pots and pans with bottom

applicable to the dimension of burner.

Do not use cooking vessels on the hotplate that

overlap its edges.

Burner Diameters of cookware

Rapid 160 - 260 mm

Semi-rapid 140 - 240 mm

Auxiliary 120 - 180 mm

Use cookware with the bottom as thick and flat

as possible.

Hob - Care and cleaning

Warning! Refer to the Safety chapters.

Warning! Switch the appliance off and let

it cool down before you clean it.

Warning! For safety reasons, do not clean

the appliance with steam cleaners or high-

pressure cleaners.

Warning! Do not use abrasive cleaners,

steel wool pads or acids, they can cause

damage to the appliance.

• To clean the enamelled parts, cap and

crown, wash it with warm soapy water.

• Stainless steel parts wash with water, and

then dry with a soft cloth.

8

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare