Zanussi ZCK67201WA Bedienungsanleitung PDF herunterladen (Seite 8)

Before first use

WARNING!

Refer to Safety chapters.

Initial Cleaning

Remove all accessories and removable shelf

supports from the appliance.

Refer to "Care and cleaning"

chapter.

Clean the appliance and the accessories before

first use.

Put the accessories and the removable shelf

supports back to their initial position.

Preheating

Preheat the empty appliance to burn off the

remaining grease.

1. Set the function and the maximum

temperature.

2. Let the appliance operate for 1 hour.

3. Set the function and set the maximum

temperature. The maximum temperature for

this function is 210 °C.

4. Let the appliance operate for 15 minutes.

5. Set the function and set the maximum

temperature.

6. Let the appliance operate for 15 minutes.

Accessories can become hotter than usual. The

appliance can emit an odour and smoke. This is

normal. Make sure that the airflow in the room is

sufficient.

Hob - Daily use

WARNING!

Refer to Safety chapters.

Ignition of the hob burner

Always light the burner before you

put on the cookware.

WARNING!

Be very careful when you use open

fire in the kitchen environment. The

manufacturer declines any

responsibility in case of the flame

misuse.

1. Turn the knob for the hob counterclockwise

to the maximum gas flow position

and

push it down to light the burner.

2. Keep the knob for the hob pushed for equal

or less than 10 seconds to let the

thermocouple warm up. If not, the gas

supply is interrupted.

3. Adjust the flame after it is regular.

WARNING!

Do not keep the knob pushed for

more than 15 seconds. If the burner

does not light after 15 seconds,

release the knob, turn it into the off

position and try to light the burner

again after minimum 1 minute.

If after some tries the burner does

not light, check if the crown and its

cap are in the correct position.

In the absence of electricity you can

ignite the burner without an

electrical device. In this case

approach the burner with a flame,

push the relevant knob down and

turn it to maximum position. Keep

the knob pushed for equal or less

than 10 seconds to let the

thermocouple warm up.

If the burner accidentally goes out,

turn the knob to the off position and

try to light the burner again after

minimum 1 minute.

The spark generator can start

automatically when you switch on

the mains, after installation or a

power cut. It is normal.

8 www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare