Zanussi ZCM660NWC Bedienungsanleitung PDF herunterladen (Seite 16)

then continue with the gas connection. The

flexible pipe is correct when:

– It cannot become hotter than room tempera-

ture or higher than 30 °C.

– It is no longer than 1500 mm.

– It does not compress.

– It is not subject to traction or torsion.

– It does not make contact with sharp edges or

corners.

– You can easily examine it in order to check

its condition.

To preserve the flexible pipe, you must regularly

check if:

– It does not show cracks, cuts or burn marks

on the two ends and its length.

– The material is correctly elastic and not hard-

ened.

– The fastening clamps are not rusted.

– It is not expired.

If you can see one or more defects, do not re-

pair the pipe, but replace it.

Important! After installation is complete, use a

soapy solution and never a flame to see if you

sealed all the pipe fittings perfectly.

The gas supply ramp is on the rear side of the

control panel.

Warning! Before gas connection

disconnect the mains plug from the

mains socket or switch off the fuse in the

fuse box. Close the primary valve of the

gas supply.

31 2

4 5

1

Gas connection point (only one point is ap-

plicable for appliance)

2

Gasket

3

Adjustable connection

4

LPG pipe holder

5

Natural Gas pipe holder

The appliance is set to default gas, to

change the setting choose pipe holder

from the list. Always use the gasket sealing

Adjustment to different types of gas

Warning! Let only an authorized person

do the adjustment to different types of gas.

This appliance is for operation with natural

gas.

With the correct injectors, you can also operate

it with liquid gas.

Warning! Before replacing the injectors,

make sure that the gas knobs are in the

Off position and disconnect the appliance from

the electrical supply. Let the appliance cool off

fully. There is a risk of injury.

Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the burn-

er.

3. With a socket spanner 7 remove the injec-

tors and replace them with the ones which

are necessary for the type of gas you use.

4. Assemble the parts, follow the same pro-

cedure backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or dif-

ferent from the necessary pressure, you must fit

an applicable pressure adjuster on the gas sup-

ply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

16

www.zanussi.com

1 2 ... 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare