Zanussi EHE642B Bedienungsanleitung PDF herunterladen (Seite 13)

1 Safety Instructions for the Installer

• A device must be provided in the electrical installation which allows

the appliance to be disconnected from the mains at all poles with a

contact opening width of at least 3 mm

Suitable isolation devices include line protecting cut-outs, fuses

(screw type fuses are to be removed from the holder), earth leakage

trips and contactors.

• In respect of fire protection, this appliance corresponds to Type Y

(IEC 335-2-6). Only this type of appliance may be installed with a

high cupboard or wall on one side.

• Drawers may not be fitted underneath the hob.

• Unless the appliance is built in above an oven there must be at least

100 mm clearance beneath the hob.

• The installation must guarantee shock protection.

• The kitchen unit in which the appliance is fitted must satisfy the sta-

bility requirements of DIN 68930.

• All cut surfaces must be sealed with a suitable sealant to protect

against moisture.

• On tiled work surfaces, the joints in the area where the hob sits must

be completely filled with grout.

• Ensure that the seal is correctly seated in the frame and that it is

seated against the work surface without leaving any gaps. Addi-

tional silicon sealant must not be applied; this will make removal

more difficult when servicing.

• The hob must be pressed out from below when removed.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Zanussi EHE642B Bedienungsanleitung Seite 13