Zanussi ZEI3921IBA Bedienungsanleitung PDF herunterladen (Seite 10)

(safety standards, recycling standards, elec-

trical safety standards etc.)

Warning! Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of volt-

age.

• If the fixing bracket is near to the terminal

block, do not let the connection cable come

in contact with the edge of the bracket.

Electrical connection

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug (if

applicable).

• The appliance must not be connected with

an extension cable, an adapter or a multiple

socket. There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed

to the side of the cabinet, in order to avoid

any contact with the equipment beneath the

cooktop.

• Make sure that there is access to the mains

plug after the installation.

Electrical Requirements

Permanent electrical installation must agree

with the latest I.E.E. Regulations and local

Electricity Board regulations. For your own

safety the installation must be done by a quali-

fied electrician (e.g. your local Electricity

Board, or a contractor who is on the roll of the

National Inspection Council for Electrical In-

stallation Contracting [NICEIC]).

The manufacturer refuses to be held re-

sponsible, if these safety measures are

not abided by.

Supply connections:

This hob has to be connected to 230 — 240 V

( 50 Hz) electricity supply.

Before carrying out the connection, make sure:

1. The limiter valve and the electrical system

can take the appliance load (see the rating

plate)

2. The supply system is equipped with an ef-

ficient earth connection in compliance

with the current standards and regulations

3. The outlet or omnipolar switch used for

connection is easily accessible with the

appliance installed.

The appliance is supplied with a 3 core flexible

power cable requiring a 13 amp plug fitted

with a 13 amp or 3 amp fuse dependent on

the load. You must purchase and install the

plug.

The wires in the cord are coloured as follows:

Green and yellow - Earth

Blue - Neutral

Brown - Live

Replacement of the connection cable

1. Connect the green and yellow (earth) wire

to the terminal which is marked with the

letter 'E', or the earth symbol

, or col-

oured green and yellow.

2. Connect the blue (neutral) wire to the ter-

minal which is marked with the letter 'N' or

coloured blue.

3. Connect the brown (live) wire to the termi-

nal which is marked with the letter 'L' and

is always connected to the network

phase.

There must be no cut or stray strands of wire

present. The cord clamp must be correctly at-

tached to the outer sheath.

10

www.zanussi.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare