Zanussi ZGS688ITX Bedienungsanleitung Seite 1

ENUser manualGas hobZGS688IL

Problem Possible cause RemedyThe flame is blow out immediately af-ter ignition• Thermocouple is not heated suffi-cient• After lightning the flame, kee

Hob recess dimensionsWidth: 560 mmLength: 480 mmHeat inputRapid burner: 2.45 kWSemi-rapid burner: 1.6 kWAuxiliary burner: 0.95 kWTOTAL POWER: G30/G31

www.zanussi.com/shop 397175201-A-462010

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4Product description _ _ _ _

damage to property caused by failure to obey these re-quirements.• To prevent the risks of structural damage or physicalinjury, installation, connecti

InstallationWarning! The following instructions aboutinstallation, connection and maintenance must becarried out by qualified personnel in compliance

3. Remove the control knob.4. With a thin screwdriver, adjust the bypass screw po-sition. If you change from natural gas 20 mbar to liq-uid gas, fully

BAA) supplied sealB) supplied bracketsPossibilities for insertionKitchen unit with doorThe panel installed below the hob must be easy to removeand let

Product descriptionCooking surface layout345121 Cooktop2 Semi-rapid burner3 Triple Crown burner4 Auxiliary burner5 Control knobsControl knobsSymbol De

342112341 Burner cap2 Burner crown3 Ignition candle4 ThermocoupleWarning! If the burner does not light after 15seconds, release the control knob, turn

Care and cleaningWarning! Switch the appliance off and let it cooldown before you clean it. Disconnect the appliancefrom the electrical supply, before