Zanussi ZWI71201WA Bedienungsanleitung Seite 12

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 28
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 11
Personalisation
Acoustic signals
The machine is provided with an acoustic device, which
sounds in the following cases:
at the end of the cycle
if there is a fault.
By pressing the 4 and 5 buttons simultaneously for about
6 seconds, the acoustic signal is deactivated (except if
there is a fault). By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unattended
so you do not need to worry that children might be injured
by or cause damage to the appliance. This function re-
mains enabled also when the washing machine is not
working.
There are two different ways to set this option:
1. Before pressing button 7: it will be impossible to
start the machine.
2. After pressing button 7: it will be impossible to
change any other programme or option.
To enable or disable this option press simultaneously for
about 6 seconds buttons 2 and 3 until on the display, the
icon
appears or disappears.
Daily use
Load the laundry
Open the door by carefully
pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them
out as much as possible.
Close the door.
Make sure that no laundry
stays between the seal and
the door. There is a risk of
water leakage or damage
to the laundry.
Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
or in the appropriate
compartment if the selected programme/option it re-
quires (see more details in "Detergent dispenser draw-
er").
If required, pour fabric softener into the compartment
marked
(the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by means of the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme.
The green pilot light of button 7 starts to flash. The selec-
tor dial can be turned either clockwise or anticlockwise.
Turn the selector dial to position
to reset the pro-
gramme/to switch the machine OFF.
At the end of the programme the selector dial must be
turned to position
, to switch the machine off.
Important! If you turn the programme selector dial to
another programme when the machine is working, the red
pilot light of button 7 will blink 3 times and the
message
Err
is displayed to indicate a wrong selection.
The machine will not perform the new selected
programme.
12
www.zanussi.com
Seitenansicht 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare