Zanussi ZCM661NX Bedienungsanleitung PDF herunterladen (Seite 25)

Electrical connection

The unit is preset to work with a voltage of single

phase 230 V.

Before making the connection make sure that:

- the energy power available in the user's house is

sufficient for the normal supply of this appliance

(see rating plate).

- the unit is correctly connected to earth through a

suitable plug and according to the installation

country Laws.

- the socket or the omnipolar switch used for the

connection must be easilv reached with the in-

stalled appliance.

The appliance is supplied with electric cable,

therefore you will have to fit it with a standard plug,

suitable for the total electric load shown on the rating

plate. The plug is to be inserted into a suitable wall

socket.

If you wish to directly connect to the mains, you

have to interpose an omnipolar switch with a

minimum opening between contacts of 3 mm, be-

tween the unit and the mains, complying with the

existing regulations.

The brown live wire (originating from the clamp

of the appliance junction box) must always be

connected to the phase of the mains supply. In any

case, the supply cord must be positioned in such a

way as it does not reach in any point a temperature

higher by 50°C than the room temperature.

mbar, undo the by-pass screw about 1/4 of a

turn, until a small regular flame is obtained.

Reassemble the parts following the same

procedure backwards.

Finally, check the flame does not go out when

quickly turning the knob from the maximum position to

the minimum position.

Replacement of the electric cable

The replacement of electric cable must

be carried out exclusively by the service

force centre or by personnel with similar

competencies, in accordance with the

current regulations.

Should the supply cord need to be replaced, use

only the following cable types: H07 RN-F, H05 RN-

F, H05 RR-F, H05 VV-F, H05 V2V2-F (T90), H05 BB-

F. It is necessary that the yellow/green earth wire is

about 2 cm longer than the live and neutral ones (see

diagram).

The section of the cable should be 3x1,5 mm

minimum.

After the connection, test the heating elements

for about 3 minutes to ensure that they are working

correctly.

The manufacturer refuses any responsability

in cases where normal safety measures are not

observed.

Ground (yellow - green)

Neutral

wire

Phase

1 2 ... 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Zanussi ZCM661NX Bedienungsanleitung Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Zanussi ZCM661NX